bearing oil

英 [ˈbeərɪŋ ɔɪl] 美 [ˈberɪŋ ɔɪl]

轴承滑油

化学



双语例句

  1. Forced lubrication for the pump, start the pump to the bearing oil.
    对于强制润滑的泵,启动油泵向各轴承供油。
  2. Flywheel with ring gear main drive gear bearing oil slinger
    有环形内齿轮的飞轮主动齿轮轴承抛油环
  3. Residual oil can be drained via valve at the rear of gear reducer and oil drain valve in thrust bearing oil sump.
    残油的排放可由减速机尾部的阀门和推力轴承油池的放油阀门来进行。
  4. Main drive gear bearing oil slinger
    主动齿轮轴承抛油环主动小齿轮锥形轴承差速器主小齿轮轴承罩
  5. Low bearing oil pressure governor bearing oil pressure trip device
    轴承低油压脱扣装置
  6. Calculation of the influences of marine shafting dynamic alignment affected by bearing oil film
    船舶轴系动态校中轴承油膜的影响计算
  7. Development of the technique and device for dynamic stability of surface tension of bearing oil
    轴承油表面张力动态稳定技术及装置开发
  8. Low bearing oil pressure governor hydrodynamic unit change pressure
    轴承低油压遮断装置液力传动装置充油压力
  9. The lubricant viscosity is one of the key factors which changes the dynamic property of bearing oil film.
    润滑油运动粘度是影响润滑油膜的动态特性的重要因素之一,粘度的改变对尾轴的振动行为产生重要影响。
  10. Application of Filmatic Bearing Oil on High-speed Rod-rolling Mill
    油膜轴承油在高速线材轧机上的应用
  11. In addition, close approximations or direct contacts between NT-LI terminals and blood vessels or neuroglial cell bodies were observed. bearing oil interface
    此外,神经降压肽样免疫反应轴突终末可与血管和神经胶质胞体相邻或者直接接触。轴承与润滑油的接触面
  12. Since the gear reducer is working with load, attention shall be paid to the temperature increase of axial cone bearing and sliding thrust bearing oil sump.
    因为减速机此时已经是带负荷运转,所以应特别注意输入轴锥轴承的温升和滑动推力轴承油池的温升有无异常现象等。
  13. Hub Bearing Oil Seal, it is mainly used in the auto hub bearing, with the features of low friction, dust and water proof and the inner framework and spring being made of stainless steel.
    主要用于汽车轮毂轴承单元,其特点是低摩擦,防泥浆和水,内骨架和弹簧采用不锈钢。
  14. Low bearing oil pressure alarm
    轴承油压下降警报器轴承低油压遮断装置
  15. Oil may be forced out through the timing cover and rear-main bearing oil seals.
    机油会从正时齿轮盖和后主轴承油封处压出。
  16. Bearing oil interface Analysis of contact stress between thief zone wellbore and bellow pipe
    轴承与润滑油的接触面油气井井漏井壁与波纹管接触应力分析
  17. Install the new upper rear bearing oil seal with the white paint facing towards the rear of the engine.
    安装新的上后轴承油封,使白漆面向引擎后部。
  18. Use of the bearing oil leak detector will determine whether or not bearing wear has been uneven.
    使用漏油检测装置即可判定轴承磨损是否均匀。
  19. Easily Missed Injuries in Severe Craniocerebral Injury Patients with Multiple Trauma Use of the bearing oil leak detector will determine whether or not bearing wear has been uneven.
    重型、特重型颅脑损伤合并易漏诊部位损伤的早期诊断和治疗使用漏油检测装置即可判定轴承磨损是否均匀。
  20. Practice of Operation and Management of Treating Waste Water Bearing Oil, Acid and Alkaline from Cold Rolling Plant
    冷轧含油酸碱废水处理运行管理实践
  21. Propeller shaft pinion flange main drive gear bearing oil slinger
    传动轴主动齿轮凸缘主动齿轮轴承抛油环
  22. The performances and the results of service test of 460 filmatic bearing oil used for morgan type no-twist wire rod mills at high speed were presented.
    介绍了摩根型无扭高速线材连轧机用460号油膜轴承油的性能及工业使用试验结果。
  23. Study on test method of load-bearing capacity of oil film of bearing oil
    油膜轴承油油膜承载能力试验方法研究
  24. The influence of the deformation angle on the dynamic damping parameters of journal bearing lubrication oil film was researched. The relation between the bearing oil film damping property and the deformation angle was obtained and analyzed by numerical method.
    研究了变形夹角对轴承油膜动态阻尼参数的影响关系,用数值计算的方法计算得到了轴承油膜阻尼参数与变形角之间的变化关系。
  25. Ester oil has good complex properties. It is introduced new applications of ester in biogradable lubricating oil, synthetic engine oil, driving system oil, metalworking fluids and dynamical bearing oil.
    酯类油具有良好的综合性能,介绍了酯类油在生物降解润滑油、合成发动机油、驱动系统用油、金属加工油和动压力轴承油等方面的新应用。
  26. By the use of a finite element method and by taking account of the non-linearity of bearing oil film force established are the shafting nonlinear equation group of the said turbogenerator.
    用有限元法及考虑各轴承油膜力非线性,建立了大型汽轮发电机组轴系非线性方程组。
  27. Some practical examples for bearing oil whip fault diagnosis and the stator coil's overheating fault diagnosis of turbogenerators are given.
    文中给出了该方法在汽轮发电机轴承油膜振荡故障和静子线圈过热故障诊断中的应用实例。
  28. The flow field experiment proved that the flow rate of bearing oil chamber using orifice compensated is not only related with the diameter of the orifice but also closely affected with the length of the orifice.
    流量实验验证了,小孔节流形式轴承油腔的流量不仅与小孔直径有关,同时小孔的长度也对其有重要的影响。